Page 1
5. Do not reach for an appliance that has fallen into water. Unplug immediately. Instructions 6. Except when charging, always un- For Care and Use plug this appliance from electri- cal outlet immediately after using. Model HC500SC 06CN1074 HC500SC_IB.indd 1...
Page 2
DO NOT REACH 7. Do not place appliance on any sur- face while it is operating. INTO THE WATER 8. Do not use this appliance with a damaged or broken comb or with WARNING – teeth missing from the blades as To reduce the risk injury may occur.
Page 3
FOR RECHARGEABLE indicator lamp will light up to indicate APPLICATION that charging has begun. Your new Conair Haircut Kit has every- 3. After recharging, store in a dry place, thing you need to achieve professional away from small children. haircuts at home. It has a powerful DC, 4.
Page 4
THE CONAIR GUIDE CONTAINS NICKEL- CADMIUM BATTERY. TO CUTTING HAIR AT HOME MUST BE COLLECTED, Before you start: RECYCLED OR DISPOSED OF PROPERLY. DO NOT 1. Inspect your clipper to make sure it is DISPOSE OF IN MUNICIPAL free of hair and dirt, is properly oiled WASTE.
Page 5
To begin cutting • Long attachment comb (number 6) cuts hair to 3/4”. hair: • Long attachment comb (number 7) 1. The hair should be cuts hair to 7/8”. combed in its natural direction. • Long attachment comb (number 8) cuts hair to 1”...
Page 6
For longer hair on holding it against the skin at the length top, use the barber desired, move the clipper downward. comb and lift hair on STOP. COMB. CHECK. the top of the head, For best results, do as the profession- cutting over als do: comb the hair often and check...
Your clipper is equipped with 2 detach- around appliance. able blade sets for routine maintenance, SPECIAL OIL cleaning and replacement. To maintain the blades of your Conair ® To remove the blade: Fig.1 clipper in peak condition, oil them after the front of the clipper every three or four haircuts.
Page 8
the same time...while you’re clipping. This taper lever eliminates the need in some situations Close Cut for an attachment comb because it lets you gradually adjust the close- Longer ness of the cut. For the closest cut and the shortest hair, push taper lever up as far as it will go to level #1.
Page 9
Conair Consumer Products Inc. will make it easy to clean. Brush 156 Parkshore Drive, or blow hair clippings from the cutter Brampton, Ont. L6T 5M1 blade. NOTE: Never pull on the clipper cord. 4. Again, snap in the blade set until you Never twist or wrap the cord around the hear a click.
Page 10
Each time you finish using the trimmer, or mustache that would most suit your face, speak with a professional hair stylist take the cleaning brush provided and and ask for an opinion on what style would brush away any loose hair that has col- be best.
TYPES OF BEARDS/ NOW YOU’RE READY TO TRIM MUSTACHES YOUR BEARD 1. Your trimmer adjusts to five positions so you can have a beard length from 3/32” (shortest) to 3/8” (longest). 2. To use the taper control, push upward for shorter cuts and downward for longer cuts.
Page 12
Get to Know Your Hair Cut Kit WARNING: IF YOU THINK Detachable THE POWER IS OFF Blade Set WHEN THE SWITCH IS OFF, Bottom Blade YOU'RE WRONG. Blade KEEP AWAY FROM WATER Turbo Adjustable button Taper Lever On/Off Everyone knows that electricity and Switch water are a dangerous combination.
LIMITED FIVE YEAR WARRANTY This warranty gives you specific legal rights, and you may also have other Conair will repair or replace (at our rights, which vary from province to option) your unit free of charge for 60 province. months from the date of purchase if the appliance is defective in workmanship or materials.