Ac Power Supply Replacement; Dc Power Supply Connection - Dell S6010-ON Installation Manual

Hide thumbs Also See for S6010-ON:

Table of Contents

Figure 18. S6010–ON AC power supply installation

1–PSU

When you install the PSU correctly, it snaps into place and is flushed with the back of the switch.

Plug in the appropriate three-prong AC power cord from the switch PSU to the external power source.

Repeat steps 1 through 4 using the second PSU slot if you have a redundant PSU.

NOTE:

The S6010–ON powers up when you connect the cables between the power supply and the power source.

AC power supply replacement

CAUTION:

Disconnect the power cord before removing the power supplies. Also, disconnect all power cords before servicing.

NOTE:

The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S6010–

ON chassis.

NOTE:

If a PSU fails, replace the entire unit. There are no field serviceable components in the PSU. To request a hardware

replacement, see

Dell

NOTE:

If you use a single PSU, install a blank plate in the other PSU slot. Dell recommends using power supply 1 (PSU1) as the

blank plate slot.

Disconnect the power cable from the PSU.

Use the grab handle to slide the PSU out of the power supply bay.

Use the grab handle on the replacement PSU to slide it into the power supply bay.

Attach the power cord to the replacement PSU.

NOTE:

The system powers up when you connect the cables between the power supply and the power source.

Each sold-separately DC PSU kit comes with a connector cable.

Support.

2–PSU slot

Power supplies

Table of Contents