Installation Recess - Dometic RMDT 8501 Installation Manual

Installation
4.2

Installation recess

The refrigerator must be installed draught-
proof in a recess (also refer to Section "4.1.3").
The measurements of the recess are stated in
the table below.
enough into the recess until the front edge of
the refrigerator casing is aligned with the front
of the recess. Allow a gap of 15-20 mm bet-
ween the back wall of the recess and the refri-
geration unit. The floor of the recess must be
level, allowing the appliance to be pushed
easily into its correct position. The floor must
be substantial enough to bear the weight of
the appliance. Install a removable screen / grill
above the oven (for fixing and removing of flue
outlet).
Ensure that the refrigerator is installed level
in the recess.
170 mm min
Appliance without grillfunction
Push the appliance far
Truma-flue outlet
AK3
removable screen /
grill
(for fixing of flue outlet)
heat reflector
ventilation grille
LS300
condenser
cooling unit
gap between coo-
ling unit and wall:
min. 15 mm
ventilation grille
LS300
Appliance with grillfunction
Observe instructions "4.3 Ventilation " !
Correct mounting of the lower ventilation grille
facilitates access to the connections and
functional parts during maintenance.
Fig. 11
12
Truma-flue outlet
AK3
removable screen /
170 mm min
grill
(for fixing of flue outlet)
heat reflector
ventilation grille
LS300
condenser
cooling unit
gap between
cooling unit and
wall: min. 15 mm
ventilation grille
LS300
Fig. 12