Huawei eA660 Series User Manual page 64

eA660 Series CPE
User Guide
Prerequisites




Procedure


----End
Issue 06 (2019-04-03)
The network deployment is complete.
The computer has been connected to the eA660.
The installation of the eA660 is complete.
The eA660 starts appropriately based on default parameters after power-on.
When the CPE fails to access the Internet, run the Ping functions to quickly check the
network connection status.
Start the IE browser, enter http://192.168.1.1 in the address bar, and press Enter.
Connect the eA660 from the near end using the Web management page.
 Use Internet Explorer 7 (IE7) or later versions.
 The default User name is Admin, and its Password is 4GCPE@hw.
Choose System > Diagnosis to display the Diagnosis page.
Set Method to Ping.
Enter the domain name in the Destination IP address or domain box.
Set Packet size and Timeout and select the Enable check box behind Do not Fragment.
Click Ping.
Wait until the operation is performed. The command output is displayed in the Result
box.
Packet Length indicates the bytes of a sent packet, and ranges from 1 to 9,000 bytes.
Timeout indicates the timeout period of each reply, and ranges from 1 to 10 seconds.
When the CPE does not run properly, the System Check can be used to preliminarily
identify the problem.
Start the IE browser, enter http://192.168.1.1 in the address bar, and press Enter.
Connect the eA660 from the near end using the Web management page.

Use Internet Explorer 7 (IE7) or later versions.

The default User name is Admin, and its Password is 4GCPE@hw.
Choose System > Diagnosis to display the Diagnosis page.
Set Method to System Check.
Click Check.
Wait until the system check is performed. The possible causes will be displayed on the
page.
Click Export to export the detailed information to the computer. If necessary, send the
detailed information to maintenance personnel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Maintenance
63