eA660 Series CPE
User Guide
Install the DHCP server and CPE and commission them so that they are ready to be
connected.
Procedure
8
This document demonstrates how the DHCP server can be configured using Windows Server
2003.
a.
Figure 4-3 Server Options > New Scope Wizard
b.
Figure 4-4 Adding a scope name
c.
Issue 06 (2019-04-03)
The DHCP clients connected to the CPE cannot obtain IP addresses from the DHCP server until DHCP
Relay and Routing Behind MS are both enabled.
Configure the DHCP server.
On the computer, go to Control Panel > Management Tools > DHCP.
From the left panel, right-click Server Options, and choose New Scope Wizard.
Add a scope name.
Set the IP address range.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Introduction
57