BMW R nineT 2019 Rider's Manual page 79

NOTICE
The start attempt is automatic-
ally interrupted if battery voltage
is too low. Recharge the battery
before you start the engine, or
use jump leads and a donor bat-
tery to start.
See the subsection on jump
starting in "Maintenance" for
more details.
The engine starts.
Consult the troubleshooting
chart below if the engine re-
fuses to start. ( 142)
Pre-Ride-Check
The instrument cluster runs a
test of the instrument dial, the
warning and indicator lights and
the display when the ignition is
switched on: this is the "Pre-
Ride-Check". The test is aborted
if you start the engine before it
completes.
Phase 1
All segments are shown in the
displays 1.
All indicator and warning lights
3 are switched on at the same
time.
Phase 2
The general warning light 2
switches from constant to
flashing.
The needle 4 for the speed
indicator moves to maximum
speed.
The needle 5 for speed moves
to maximum speed.
Phase 3
The needle 4 for the speed in-
dicator goes down to zero.
The needle 5 for the speed goes
down to zero.
The indicator and warning lights
go out or assume operational
status, as applicable.
The malfunction indicator lamp
only goes out after 15 seconds.
The display switches to its ordin-
ary display mode. The on-board
computer readings appear on the
display.
If needles do not move, an in-
dicator and warning light is not
switched on or there are missing
segments in the display:
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.
6
77
z