Henny Penny Velocity Series Service Manual page 60

4 4 . . 2 2 0 0 L L a a b b e e l l R R e e p p l l a a c c e e m m e e n n t t
If a label becomes unreadable it should be replaced. These procedures explain how
to remove a label and prepare the surface for the new label. In certain situations it
may be quicker and more cost effective to replace the component on the fryer, which
ships with a new label attached. As an example, a PXE model fryer has multiple labels
50
11. Insert both cables in to the holes in the
chassis, screw a 5/16" nut on to the
end of each of the cables, and then
tighten.
I I N N F F O O : The lifting cable tension should be
tight and the safety cable tension should
be loose enough that when squeezing the
cable together, the two sides can touch.
12. Tighten the lock-nut against the top of
the bracket, securing the cable.
13. Remove the two carriage bolts
securing the weight carriage against
the fryer's frame. Retain the bolts for
future use.
14. Raise the lid up and down to ensure
free movement
carriage and that it is level. Correct
as needed.
15. Replace the top cap and rear shroud.
16. After replacing both cables, locate the
white label. Using a marker or pen,
write the cable replacement month
and year on the white label as
shown.
17. Place the label on the back of the fryer
in the area indicated.
18. Place the clear label protector overtop
of the white label to prevent ink from
wiping away during future cleaning.
of the weight