Installing An Nimh Battery Pack - Symbol PDT 1100 Product Reference Manual

PDT 1100 Terminal Product Reference Guide
2. Insert the two new AAA alkaline batteries using the proper polarity.
3. Replace the battery cover, being careful not to pinch the battery pull strap between
its cover and the bottom cover. Return the battery cover lock to its original position.

Installing an NiMH Battery Pack

To install the NiMH battery pack:
1. Charge the NiMH battery pack (refer to instructions in
and Terminal
in the direction of the arrow and remove the battery cover.
2. Install the battery pack with the proper polarity so that the end of the battery pull
strap appears above the battery pack. This facilitates easy removal of the pack.
Grooves on the battery pack must align with the slot.
3. Replace the battery cover, being careful not to pinch the battery pull strap between
its cover and the bottom cover. Return the battery cover lock to its original position.
1-6
Battery Cover
Battery Cover
Figure 1-3. Installing AAA Batteries
Maintenance). Turn the PDT 1100 upside down. Slide the cover lock
Figure 1-4. Installing the Battery Pack
Alkaline Batteries
Battery Cover
35864042.eps
Chapter 5, Battery Charging