Invacare Soft Tilt User Manual page 8

Invacare® Soft Tilt
3.
Insert the loose ends of the two slats underneath the
cover plates of the main module and insert them back
into the bracket N on the other side.
4.
IMPORTANT!
Do not hold the main module on the middle
plate while lifting, as it can become loose.
Place the main module with slats assembly onto the
crossbars P, with the long connection arms O facing
towards the head end of the bed. Ensure that the cables
of the motors run between the crossbars P and no
cables are squeezed. Fix the slats assembly with bolts K
and nuts J removed in step 1.
5.
Ensure that the main module is placed in the middle of
the mattress support frame and the distance to the side
tubes is the same on both sides. Fix the main module
to the crossbars of the mattress support frame, with the
fixation plate washers and nuts, from underneath on
both sides of the bed.
8
Wiring
The control box and hand control is to be hung at the
footboard.
Connections at the control box
• Q Power supply
• R Hand control and squeeze protection switches via
splitter cable
• S Right motor
• T Left motor
1. Connect the cables of the right and left motor to the
two extension cables S and T from the control box.
2. Connect the hand control to the shorter end of the
splitter cable R and connect the power cable Q to the
mains.
3. Deactivate the emergency stop, turn the system on,
activate manual mode and use the hand control to check
that the left and right motor are correctly connected
to the control box (see chapter Usage for detailed
instructions).
1605513-A