Table of Contents
Advertisement
6. Seat the module by pushing on the sheet metal tray until the plastic bezel contacts the chassis.
7. Tighten the module's captive screws using a Phillips screwdriver. See
Figure 5: Installing an Interface Module
NOTE:
Tighten the captive screws completely before installing an adjacent module so that proper
electromagnetic interference (EMI) gasket compression occurs. Failure to do this can make it difficult to
install adjacent modules.
Connect the Management Console
The CTP151 device has a console port with an RJ-45 connector. Use the console port to connect the device to a
management console or to a console server.
Before you begin, ensure that you have a rollover cable available.
To connect the CTP151 device to a management console through a console server (see
1. Connect one end of the rollover cable to the console port (labeled CON).
2. Connect the other end of the rollover cable to the console server (see
Figure
5.
Figure
6):
Figure
6).
7
Advertisement
Table of Contents
