Empire Comfort Systems DVLXG55BP90N Installer's Manual page 49

MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS
Initializing the System for the First Time
1. Ensure that the fireplace has power.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter.
3. Press the BLACK pairing button located at the very bottom
left hand corner of the fireplace in the opening below the glass.
The SIT controller inside the fireplace will beep three times to
indicate that it is ready to synchronize with the transmitter.
Green Black
4. Push the 'ON' button on the transmitter within 10 seconds.
The SIT controller will beep four times to indicate that the
transmitter's command is accepted. The system is now initialized.
Should the SIT controller be replaced with a brand new controller
then it may be necessary to hold down the GREEN button
throughout the whole pairing procedure above.
Temperature Indication Display °C or °F
With the system in the OFF position, press the thermostat
button and the mode button at the same time. Look at the LCD
screen on the transmitter to verify that a °C or °F is visible to
the right of the room temperature display.
Room Temperature
Set Temperature
Room Temperature
Set Temperature
49