SATO CL4NX Plus Operator's Manual page 466

Hide thumbs Also See for CL4NX Plus:

Table of Contents

[Configure List]

Print the product's settings information.

1. Check and set the items as listed on the [Configure List] menu.

2. Press the

To stop the test print, first pause the print and then press the

The setting items are as follows:

Shows the necessary media width of the test print.

The necessary media width is 50.8 mm (2") for [Small].

Label Length

Set the length of one piece of the media used for the test print.

The setting range varies depending on the print resolution of the product.

The setting range is as follows:

(1 dot = 0.125 mm (0.0049"))

(1 dot = 0.083 mm (0.0033"))

(1 dot = 0.042 mm (0.0017"))

button to start the test print. Press the

400 to 1600 dots

600 to 2400 dots

1200 to 4800 dots

[Test Print]

button again to pause the