Figure 2-30 Flatten six center tabs on base section
Figure 2-31 Assembling the ring and mounting the sensor
2. Assemble the Scissors Ring, attach the sensor, and secure
the cables above ground.
3. Assemble the ring, making sure the tongue sections are
fully inserted into the slotted sections and over the secur-
ing buttons.
4. Bolt the sections together to increase safety and prevent
the assembly from being dislodged or separated by the flow
stream.
Bolt holes
ADFM® Flow Meter
Section 2 Setup and Installation
Pro20 sensor with debris fairing
2-31