▍
Hardware Setup
connector
Serial ATA Connector: SATA1 ~ SATA4
This connector is a high-speed Serial ATA interface port. Each connector
can connect to one Serial ATA device.
Important
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.
Fan Power Connector: CPUFAN1 / SYSFAN1
The fan power connectors support system cooling fan with +12V. When
connecting the wire to the connectors, always note that the red wire is the
positive and should be connected to the +12V; the black wire is Ground
and should be connected to GND. If the mainboard has a System Hard-
ware Monitor chipset on-board, you must use a specially designed fan
with speed sensor to take advantage of the CPU fan control.
Important
•
Please refer to the recommended CPU fans at processor's official
website or consult the vendors for proper CPU cooling fan.
•
Fan cooler set with 3- or 4-pin power connector are both available
for CPUFAN1.
2-8