Section 2: Installation And Wiring; Installation Options - Honeywell NOTIFIER UDACT-2 Instruction Manual

Universal digital alarm communicator

Table of Contents

2.1 Installation Options

The UDACT-2 is either installed internally in the panel cabinet or remotely in an ABS-8RB, UBS-1B or UBS-1R enclosure. The follow-

ing table contains information specific to each panel that is compatible with the UDACT-2. See "Internal Installation" on page 13 for

instructions on internal installation and "Remote Installation" on page 17 for instructions on remote installation. Additional information

required for installing the UDACT-2 in a specific Fire Alarm Control Panel will be found in the appropriate appendix relating to that

panel.

Host Control Panel

AFP-200

AFP-300/AFP-400

AM2020/AFP1010

NCA-2

NCA

NFS2-640

NFS-320

NFS-320SYS

NFS-640

NFS2-3030

NFS-3030

Internal Installation

CAUTION:

REMOVE ALL POWER FROM THE CONTROL PANEL BY DISCONNECTING AC AND BATTERIES BEFORE

INSTALLATION OR MAKING ANY CONNECTIONS TO PREVENT PERSONAL AND/OR CIRCUIT DAMAGE.

Mounting on the NFS-320 Chassis



The UDACT-2 is installed on the chassis within the NFS-320 backbox as described and shown below:

Step

Action

Disconnect AC power and disconnect batteries.

Remove the KDM-R2 keypad. Do not remove the onboard power supply.

Remove the two 1" standoffs from the bottom of the CPU and replace with the two #4-40 x 0.5" standoffs provided with

the UDACT-2.

Position the UDACT-2 on the standoffs and fasten with two #4-40 x 0.25" screws provided.

Onboard

Power Supply

UDACT-2 — Instruction Manual P/N 54089:B3 10/29/2019