Dual Configuration Settings - D-Link DGS-3200 Series User Manual

Dual Configuration Settings

The following window displays dual configuration settings on the Switch. The Switch allows two firmware images to be stored in
its memory and either can be configured to be the boot-up firmware for the Switch. The user may select a boot-up firmware image
for the Switch by clicking the Boot button to select it. This will instruct the Switch to use this newly selected firmware the next
time the Switch is restarted. To delete a firmware image, click the Delete button. The Active button indicates active firmware.
To access the following window, click Configuration > Dual Configuration Settings.
The following parameters may be configured or viewed:
Parameter Description
ID States the image ID number of the firmware in the Switch's memory. The Switch can store 2
firmware images for use. Image ID 1 will be the default boot-up firmware for the Switch unless
otherwise configured by the user.
Version States the firmware version.
Size States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch. Boot-up files are denoted by an asterisk (*) next to the file.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade through the web-
based management interface.
SSH - If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Secure Shell network protocol.
SIM – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Single IP Management feature.
User States the user who downloaded the firmware. This field may read "Anonymous" or "Unknown"
for users that are not identified.
Boot An asterisk indicates which firmware is used for boot-up by the Switch.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 28. Dual Configuration Settings window
48