Paper Selection
You can manually specify a paper size or set the machine to automatically select
the paper size for you.
2
IMPORTANT
If you want to copy an 11" x 17" original with an image that extends all the way to the
edges without the periphery of the original being cut off, load the stack bypass with
12 5/8" x 17 11/16" or 12" x 18" paper, or load a paper drawer with 12" x 18" paper. (See
"Platen Glass," on p. 1-23, and "Entire Image," on p. 2-37.)
NOTE
•
If you are copying an original with an image that extends all the way to the edges onto the
same size paper at a copy ratio of 100%, the periphery of the original image may be cut
off slightly on the copy. For more information on how much may be cut off, look under the
margin areas in the Specifications table in Chapter 9 "Appendix," in the Reference Guide.
•
If you select the Entire Image mode, the copied image is automatically reduced slightly
based on the copy paper size and the image size. As a result, the entire original image is
reproduced on the copy without being cut off. (See "Entire Image," on p. 2-37.)
•
If you select [Envelope], [Transparency], [Tracing Paper], [Labels], [Tab Paper], or [Washi
(JPN paper)], make sure that you do not specify any Finisher modes (Collate, Group, or
Staple).
•
If Stack Bypass Standard Settings in Common Settings (from the Additional Functions
screen) is set to 'On', and the paper size/type have been stored, the selected paper size/
type are displayed on the screen. (See Chapter 4, "Customizing Settings," in the
Reference Guide.)
•
For instructions on loading paper into the stack bypass, see Chapter 2, "Basic
Operations," in the Reference Guide.
•
The default setting is 'Auto'.
2-6
Paper Selection