Table of Contents
Advertisement
Installation
Installing Front Handles/Rack Mounting Flanges
Figure 2-3
Installing front handle/rack-mount kits
How to Install the Handle Kit (Option 1CN)
The handle kit is used for transport and relocation of the E5071C. While referring to Figure
2-3, install the handle kit by following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame of the
E5071C front panel.
Step 2. Use the provided screws to mount the front handles (2) on each side of the E5071C front
panel frame.
Step 3. Attach the provided modified trim strip (3) to each front handle in order to cover the front
panel locking screws.
WARNING
If the installed front handle becomes damaged, replace it with a new one immediately.
A damaged handle can break while moving or lifting the instrument and cause
personal injury or damage to the instrument.
18
Chapter 2
Advertisement
Table of Contents
Troubleshooting
