Table of Contents
Advertisement
Installation
Starting the E5071C
This operation turns ON the power, and the E5071C starts the self-test.
Step 4. Confirm that the self-test indicates normal operation.
Normal operation is confirmed by the self-test if no error message appears.
Turning the Power OFF
Step 1. Use either of the following methods to turn the power OFF.
•
•
These operations will start the E5071C shutdown process (required software and hardware
processes for turning the power off), and the power will turn OFF after a few seconds.
NOTE
Under normal circumstances, always press the standby switch (
Computer from Windows Start menu, to execute the E5071C shutdown process. Never cut
off the power supply directly by disconnecting the power cable plug from the rear
panel of the unit.
If the power supply is cut off directly by disconnecting the power cable plug from the
instrument or the AC outlet, the shutdown process is not carried out and there is a risk of
damage to the E5071C's software or hardware.
Figure 2-7
Line switch (Always ON) and power cable receptacle
e5071cqe1003
24
Press the standby switch (
pressed down (
) position) to put it in the popped up (
Click Turn off Computer from Windows Start menu
Power Cable Receptacle
Line Switch: Always ON ( | )
Switch must remain
ON while operating.
115 V
50/60 Hz
REF IN
REF OUT
AUX IN 2
10 MHz
1 V, 10 V
REF OVEN
(10 MHz)
) in the lower-left part of the front panel (now in the
LR95111C
ICES/NMB-001
ISM 1-A
N10149
24 BIT I/O
WARNING:
No operator serviceable
parts inside. Refer servicing to qualified
NOTE
personnel.
-
230 V
350 VA Max
LINE
AUX IN 1
I/O PANEL
PRINTER
ETHERNET
(PARALLEL)
RESERVED
1
3
RESERVED
VIDEO
2
4
FUSE 0.5 A
PORT 4
PORT 3
PORT 2
PORT 1
BIAS INPUT
35 VDC Max
) position.
), or click Turn off
EXT TRIG
GPIB
IN
USB
EXT TRIG
OUT
Model# Label
Serial Label
Windows Label
Chapter 2
Advertisement
Table of Contents
Troubleshooting
