Display - HTC 800 RXP User Manual

Always use approved protective boots
Risk of fire. Only us commercially
available floor cleaners and waxes
intended for machine application.
Risk of explosion. Grinding can cause an
explosive mixture of fine dust and air.
Only use a grinding machine in a area
with good airflow.
Use only in areas with good airflow. Take
precautions against exposure to carbon
monoxide (CO) emissions.

1.7 Display

MENU
SET
1.7.1 RPM
The display shows the rpm of the engine.
• Idling: 0 - 1400 rpm.
• Operating range: 2000 - 3600 rpm.
CAUTION: Do not run the machine between
1400 - 2000. The clutch can slip.
1.7.2 Clock
The display has a clock.
• The clock can show current time. Press MENU once
and use SET button to change the time. Press and
hold the MENU button to return to mainpage.
• The clock can show the total runtime. Press the
MENU button once.
• The clock can show time to next scheduled service.
Press and hold the MENU button until the symbol
SUC shows.
•
6 - Introduction
rpm
450 630 810
RPM
1.7.3 Warning
The display shows warning symbols.
• Low battery warning. The display shows the symbol
LOU and a warning triangle.
• Service warning. The display shows the symbol
SUC and a warning triangle.
1.7.4 Display settings
The MENU button and the SET button adjusts the
settings on the display.
• Press the MENU button to toggle through the
settings.
• Press and hold the MENU button to activate the
setting.
• Use the SET button to adjust the setting.
• Press the MENU button once to lock the setting.
• Press and hold MENU to return to mainpage.
Note: The display returns to the mainpage if inactive
during 10 seconds.
1.7.5 Display menu
Use the MENU button and the SET button to adjust the
settings on the display.
Menu items
Total runtime
Time to next service
Max rpm
Ignition
RPM limit
RPM warning
Service warning
Voltage warning
Battery voltage
Reset to factory settings
Explanation and basic
settings
Displays total runtime.
Press and hold MENU to
reset the interval after
service.
Shows the max rpm used
during last work session.
Set to "1P1r".
2000 - 3600 rpm
Set to "OFF".
Set to 100h.
Set to 11,0V.
Shows UOL and voltage in
V.
Do not use.
888 - 001 -