To Access The Grinding Tools; To Fit The Grinding Tools; To Remove The Grinding Tools; To Move The Machine Manually - HTC 800 RXP User Manual

5.6 To access the grinding tools

WARNING: Before you change the tools, you
must read and understand the safety chapter.
1. Set the handle to the rear position.
2. Fold the weights back and place a foot against one
of the weights.
3. Tip the machine backwards carefully, until the
weights reach the floor.
4. Tip the machine further back, until all of the machine
reaches the floor.
888 - 001 -

5.7 To fit the grinding tools

1. Slide the grinding tool diagonally, from above, down
into the appropriate guide slot on the tool holder.
Then push the tool fully into the guide slot.
2. Lock the grinding tool into the tool holder by giving it
a few light taps with a rubber hammer.

5.8 To remove the grinding tools

1. Remove the grinding tool by giving it a few light taps
with a rubber hammer so the locking mechanism
releases.
2. Pull out the tool.

5.9 To move the machine manually

1. Turn the power switch to off.
2. Release the drive lock on the wheels. See
the drive lock on the wheels on page 13 .
To adjust
Operation - 15