To Use The Remote Control To Move The Machine; To Operate The Grinder Manually; To Operate The Grinder With The Radio Control Unit - HTC 800 RXP User Manual

3. Attach the support wheel. See
wheel on page 14 .
4. Move the machine with the handle.
5.10 To use the remote control to move the
machine
1. Lock the drive lock on the wheels. See
drive lock on the wheels on page 13 .
2. Turn off the propane.
3. Turn the START KEY SWITCH to I.
4. Turn the RADIO ON/OFF switch to I.
5. Press the START RADIO COMMUNICATION button
on the remote control unit. The red led bulb (COM
ERROR) on the control panel goes out, if the
connection is successful.
6. Use the FWD/RWD switch and STEERING knob to
move the machine.

5.11 To operate the grinder manually

CAUTION: The emergency stop switch, (EM-
Stop) must only be used in an emergency.
Usage may decreases the lifespan of the
machine's electrical components.
Note: Drive the machine manually in difficult to navigate
spaces.
The operator pushes the machine forward across the
floor surface and operates the machine with the control
panel.
5.11.1 To start
1. Release the drive lock on the wheels. See
the drive lock on the wheels on page 13 .
2. Connect the propane cylinder to the propane hose.
Make sure that the propane tank and the hose is
properly connected and that the hose is properly
connected to the fuel lockoff safety valve on the
engine.
3. Turn the propane cylinder valve counter clockwise
until it stops to activate the flow of the propane.
4. Examine the connections for propane leaks.
Propane emits a foul "garbage" odor. If a leakage
occurs do not continue to start the machine. Fix the
leakage before you start the machine.
5. Turn the main power switch to "ON".
6. Release the EM-stop.
7. Turn the START KEY SWITCH to II.
8. Make sure that the RADIO SWITCH is in its "0"
position.
16 - Operation
To use the support
To adjust the
To adjust
9. Turn the START KEY SWITCH to the right to start
the engine. Do not try to start the engine for more
than 5 seconds at a time. Excessive starter running
may result in damage to the starter. The engine can
require more than one start attempt.
10. Before you operate the product, wait 3 - 5 minutes
and let the engine become warm. Idle at max. 1400
rpm.
5.11.2 To stop
1. Push the THROTTLE knob. This will set the engine
to the idle position.
2. Turn the propane cylinder valve clockwise until it
stops to turn off the propane supply to the engine.
Allow the engine to burn all the fuel in the line.
3. Turn the START KEY SWITCH to "0".
4. Turn the main power switch to "OFF".
5.12 To operate the grinder with the radio
control unit
WARNING: Do not leave the machine
unattended when operating using the radio
control unit.
Note: Drive the machine manually in difficult to navigate
spaces.
When you use the radio control unit to operate the
machine, the machine moves forward with the aid of the
motors in the drive motor box.
5.12.1 To prepare the radio control unit
Note: Rechargeable batteries must be fully charged
before they are used for the first time.
1. Remove the screws on the battery cover on the
radio control unit.
2. Put two charged AA batteries 1.2 V NiMH, or two
non-rechargeable 1.5 V AA batteries, in the battery
conpartment.
3. Close the cover and tighten the screws.
888 - 001 -