AEG L61270BI User Manual page 20

20 www.aeg.com
12.7 Cleaning the inlet hose and the valve filter
1.
1
2
3.
12.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water flow out of the hoses.
2
1
3
8. Put the cap back on the emergency
emptying hose and place the latter back in its
seat. Replace the filter into the pump by
inserting it correctly into the special guides.
Screw the filter cover firmly by turning it
clockwise.
2.
4.
20°
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to Off to
disconnect the appliance from the
power supply.
6. Screw the water inlet hose back on
and re-fit the emergency emptying
hose after having put the cap on
again.
45°