Procedure - Converting From Standard To Loop Stitching; Adapting The Stitch And Leg Length Settings - Hohner UNIVERSAL 52/8 S Operating Instructions, Spare Parts List, Special Staples, Options

3.11 Procedure - Converting from standard to loop stitching

- Fig. 21 -
- Remove stitching head (see Chap. 3.1).
- Replace former lever
- Remove former (cf. 4.2.1 Replacing the former).
- Remove bender (cf. 4.2.2 Replacing the bender).
- Remount bender and former for loop stitching in the inverse order.
- Remove knives box
knives box by 4 mm to the left. Place knives box at the left fastening point of the guide and
tighten screws .
- Install and set stitching head (see Chap. 3.1).

3.12 Adapting the stitch and leg length settings

As the loop stitch requires a longer wire piece, a new setting is required for the stitch and leg
length (cf. 3.6 Setting the stitch length).
Hohner Maschinenbau GmbH
Art. No. 9963 590 with former lever –L- Art. No. 9963 840.
by undoing the screws
HK 52/8 S
at the right fastening point of the guide. Move
Operation
41