Setting The Stitch Length; Basic Setting Of The Stitch Length; Fine Adjustment Of The Stitch Length - Hohner UNIVERSAL 52/8 S Operating Instructions, Spare Parts List, Special Staples, Options

3.6 Setting the stitch length

3.6.1 Basic setting of the stitch length

The setting is dependent on the stroke length of your machine.
Basic setting is done ex works (referred to a stroke of 49 mm).
Normal stitching:
Loop stitching standard stitch -L6-:
Loop stitching special stitch - L8 -:
When changing from normal stitching to loop stitching (standard -L6-) or vice-versa the stitch
length required must be adapted.
Turn the knob clockwise (+) for feeding more wire, anticlockwise (-) for feeding less wire.

3.6.2 Fine adjustment of the stitch length

- Fig. 11 -
Fine adjustment of the wire length is performed by means of test stitches. If the stitch is not the
required length, more wire can be fed by turning knob
the knob (-) (cf. scale
Hohner Maschinenbau GmbH
The recommended wire length for 2-sheet stitching is approx. 26 mm,
the stitching unit must then be set to 2-sheet stitching.
The recommended wire length for 2-sheet loop stitching is approx.
32 mm, the stitching unit must then be set to 2-sheet stitching.
The recommended wire length for 2-sheet loop stitching is approx.
40 mm, the stitching unit must then be set to 2-sheet stitching.
).
HK 52/8 S
(+), or less wire can be fed by turning
Operation
29