Straighten The Stitching Wire - Hohner UNIVERSAL 52/8 S Operating Instructions, Spare Parts List, Special Staples, Options

3.5 Straighten the stitching wire

- Fig. 10
The stitching wire must run absolutely straight out of the circular knife. The wire feed can be set to
run absolutely straight by turning the wire alignment roller
bearings.
Wire straightening procedure:
- First remove former. (cf. 4.2.1)
a) Activate the machine's jog switch if possible.
b) Manual wire feed (cf. 3.2 Feeding the stitching wire)
Wire can be fed by turning the provided adjusting handle in the clockwise direction. When
doing this, it is a good idea to cut off any overlong pieces of wire, by pressing down the knife
slider (possible by "levering" the rocker
- Turn eccentric fixing of the wire alignment roller
runs absolutely straight out of the circular knife.
Hohner Maschinenbau GmbH
which is arranged on eccentric
).
with the screwdriver until the stitching wire
HK 52/8 S
Operation
27