Remove Control Panel; Remove Evaporator Plate / Fins; Remove Refrigerator And Upper/Lower Door Hinges; Disconnect Heaters / Temperature Monitor Control (Tmc) / Igniter Wire - Norcold 2118 Manual

Gas electric refrigerators. cooling unit replacement
Hide thumbs Also See for 2118:
Table of Contents

Advertisement

Available languages

Available languages

Disassemble, cont'd.

Remove Control Panel

2.4
2.4
B
C

Fig. 6 - Control Panel and Water Dispenser

A. Control panel screw
B. Control panel
C. Water dispenser or dummy plate screw
D. Water dispenser or dummy plate
1. Disconnect wire harness connectors located at back side of control
panel; set aside.
2. Remove screw (Fig.6,C). Remove dummy plate or water dispens-
er (Fig.6,D).
3. Disconnect in line electrical connector.
4. Disconnect water line from spigot; set aside.

Remove Evaporator Plate / Fins

2.5
2.5

Fig. 7 - Evaporator Plate / Fins

A. Fins
B. Clip and thermistor
C. Freezer evaporator plate screws
1. Pull the clip and thermistor (Fig.7,B) off of the second fin from the
right. Allow the clip and thermistor to hang free. Do not discon-
nect the thermistor.
2. Remove fins (Fig.7,A) from the low temperature evaporator plate
of the cooling unit (8x).
3. Pull the fins toward you and up to remove. Mark top of fins to
reinstall correctly later. Lay fins aside.
4. Remove freezer evaporator plate screws (8x) (Fig.7.C).
2.6
2.6
A
D
!
1. If RV is equipped with drawer or door beneath refrigerator enclo-
sure, remove to avoid damage.
2. Place soft pad waterproof tarp on floor. Moisture may drain from
unit.
3. With assistance, pull refrigerator completely out of enclosure and
lay on side. To help move the refrigerator, use the lifting handles
attached at the middle front and rear of each side.
4. Remove upper and lower door hinges (Fig.4,L) (16x). Set aside.
5. With assistance, turn the refrigerator to lay face side down.
2.7
2.7
Place sharp edge
of washer away
from wall.
C
B
A

Fig. 8 - Temperature Monitor Control (TMC)

A. Thermocouple
B. Temperature monitor control (TMC)
1. Unplug the thermocouple (Fig.8,A) from the temperature monitor
control (TMC) (Fig.8,B).
6
NOTE:
Do not remove the top two (2) screws or remove the ice
maker.

Remove Refrigerator and Upper/Lower Door Hinges

Danger!!!
Very heavy object. Do not attempt to remove without help.
Unassisted removal will likely cause bodily injury, property damage, or both.
Disconnect Heaters / Temperature Monitor Control (TMC) /
Igniter Wire
A
B
www.norcold.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents