Table of Contents
Advertisement
Operating the Refrigerator Controls
AC Operation
120 volts AC
(108 volts min.-132 volts max.)
12 volts DC - control voltage
(10.5 volts min. - 15.4 volts max.)
The refrigerator operates on these energy sources. Operation
out of these limits can damage the refrigerator electrical
components and will void the warranty.
Control panel:
The refrigerator control panel (See Art01333) is between the
freezer compartment and the fresh food compartment. To
maintain the operating control functions of the refrigerator, a 12
volt DC power supply is necessary. The refrigerator receives
DC power from the 12 volt system of the vehicle; either an
auxillary battery, a converter, or the vehicle engine battery.
The ON / OFF button [1] starts and shuts down the refrigerator:
- To turn on the refrigerator, push and release the ON / OFF
button.
- To turn off the refrigerator, push the ON / OFF button for two
seconds and then release.
The SET TEMP button [2] controls the temperature adjustment
of the freezer and the fresh food compartment.
- Push the SET TEMP button and the temperature setting (the
numbers "1-9") show in the center display [3].
- The number "9" is the coldest temperature setting.
- Push and hold the SET TEMP button and the temperature
setting changes.
- Release the SET TEMP button when the temperature
setting that you wish appears.
- After ten seconds, the temperature setting will go out and
only a green power ON light remains.
NOTE: Push and release the MODE button [4] to show "AC",
the current mode of operation, in the center display
for 10 seconds.
- If 120 volts AC is not available to the refrigerator:
- The fault codes "no" "AC" shows in the center display
and an audible alarm sounds.
If 120 volts AC is available to the refrigerator, but is not operating
correctly:
- A fault code shows in the center display.
- An audible alarm starts.
- Refer to the "Fault Codes" section of this manual.
Cooling unit sensing:
The controls have the ability to sense the operation of the
cooling unit. If the controls sense that the cooling unit has
stopped cooling:
- The heat source to the cooling unit is turned off and locked
out by the controls.
- An audible alarm starts.
- A fault code "no" "co" shows in the Center display.
You can reset the controls and remove this fault code one time.
To reset the controls, shut off and then start the refrigerator.
- To turn off the refrigerator, push the ON / OFF button for two
seconds and then release.
- To turn on the refrigerator, push and release the ON / OFF
button.
If you reset the controls and the fault occurs again before the
refrigerator completes a full cooling cycle:
- The heat source to the cooling unit is turned off and locked
out by the controls.
- An audible alarm starts.
- A fault code "no" "co" shows in the Center display.
- This time you can not reset the fault. Have the refrigerator
serviced by your dealer or a Norcold authorized Service
Center as soon as possible.
Ice Maker (Optional)
The ice maker is assembled to the refrigerators at the factory as
optional equipment. If the refrigerator does not have a factory
installed ice maker, one cannot be added to the refrigerator at a
later time.
Owner's Manual 7
Advertisement
Table of Contents
