MULTIQUIP Essick Series Operation And Parts Manual page 46

1
7
SAFETY
INSTRUCTIONS
1. Read owner's manual
before operating.
2. Keep unauthorized and untrained
people away from machine during
operation.
3. Make sure all safety devices are in
place before this machine is started.
4. Make sure engine is turned off and
6
spark plug wire is disconnected before
cleaning the machine.
5. Keep hands and ngers away from
CAUTION
moving objects.
6. Do not operate machine in an enclosed
area, proper ventilation is required.
INSPECT BEFORE TOWING
7. Never leave machine unattended when
TIGHTNESS OF WHEEL NUTS
operating.
TIRE PRESSURE
8. Always stop engine and allow engine
to cool before adding fuel or oil. 1. Use manufacturer's recommended torque values
520935
when tightening wheel lug nuts.
2. Use manufacturer's recommended tire pressure
5
values when inating tires. DO NOT exceed
recommended tire pressure.
8
13
14
12
CAUTION
DRUM LOCK POSITIONING
SEE OPERATION MANUAL FOR PROPER
DRUM LOCK POSITIONING
LEGEND
REPRESENTS LOCK PIN
REPRESENTS DRUM STOP BLOCK
MIX TOW
P/N 521231
PAGE 44 — EM12M SERIES PLASTER/MORTAR MIXER • OPERATION AND PARTS MANUAL — REV. #2 (09/09/19)
NAMEPLATE AND DECALS ASSY.
2
3
WARNING
To avoid injury, you MUST read and
understand operator's manual before
using this machine.
Keep safety grate, guards and doors
in place. Shut off engine or electric
motor before inspection or maintenance.
Moving parts can cut and crush.
SHUT OFF engine or electric motor
before placing hands in mixing drum.
This machine to be operated by qualied
personnel only. Ask for training as needed.
P/N 521229
P/N 521232
MANAGEMENT SYSTEM
3
11
4
TRANSMISSION
OIL
9
QUALITY
CERTIFIED ON
ISO 9001:2008
518524
CAUTION
INSPECT BEFORE TOWING
TIGHTNESS OF WHEEL NUTS
TIRE PRESSURE
1. Use manufacturer's recommended torque values
when tightening wheel lug nuts.
2. Use manufacturer's recommended tire pressure
values when inating tires. DO NOT exceed
recommended tire pressure.
WARNING
To avoid injury, you MUST read and
understand operator's manual before
using this machine.
Keep safety grate, guards and doors
in place. Shut off engine or electric
4
motor before inspection or maintenance.
Moving parts can cut and crush.
SHUT OFF engine or electric motor
before placing hands in mixing drum.
This machine to be operated by qualied
personnel only. Ask for training as needed.
P/N 521229
15
FILLER
P/N 948013
CLUTCH
OIL FILLER
17
ENGINE
OIL FILLER
P/N 94805
2
IMPORTANT
SELF-ADJUSTING SEALS PROTECT
PADDLE SHAFT AND BALL
Three easy safeguards
1. BREAK IN
Break in has been taken at the factory. No adjustments or
special procedures are required.
2. MAINTENANCE
Keep drum and spring area clean. Repack with one new ring
of packing and waterproof grease when gland is about to
bottom or when springs have extended to a length of 2 inches.
Retighten springs to 1-1/2 inches.
2. NEW PACKING
Coat shaft and packing generously with a good grade
of waterproof grease. Also pack this grease around
the paddle shaft ball bearings in drum head cavity,
when shaft is removed. Tighten the two springs nuts
on each end until length of spring is compressed to
1-1/2 inches.
5
ESSICK
CONSTRUCTION PRODUCTS. A MULTIQUIP
COMPANY
P/N 521232
2
16
P/N 948012
10