General Information - MULTIQUIP Essick Series Operation And Parts Manual

APPLICATION
This mixer is only intended for the mixing of plaster and
mortar. The mixer must be used for its intended purpose
and is not suitable for the mixing of flammable or explosive
substances. The mixer must not be used in an explosive
atmosphere.
The drum capacity of this hydraulic mixer is 12.0 cu. ft.
(340 liters) with a batch capacity between 3-1/2 and 4-1/2
bags. Mixer is shipped completely assembled and has been
factory tested and is ready for use.
POWER PLANTS
Mixer is powered by a 11.7 HP, air-cooled, 4-stroke gasoline
engine or a 5HP electric motor . Refer to Table 3 or Table 4
for specific engine or electric motor specifications.
HARDWARE
Check all hardware on the mixer before starting. Periodically
inspect all hardware. Loose hardware can contribute
to early component failure and poor performance. Use
Table 5 as general guideline when the torqueing of mixer
hardware is required. Remember to keep all mixer hardware
components tight.
Table 5. Hardware Torque Recommendations
Hardware Diameter
5/16-inch x 18
3/8-inch x 16
3/8-inch x 24
1/2-inch x 13
1/2-inch x 13 (Grade 8)
EM12M SERIES PLASTER/MORTAR MIXER • OPERATION AND PARTS MANUAL — REV. #2 (09/09/19) — PAGE 15
Torque (ft-lbs)
14
24
37
39
90

GENERAL INFORMATION

ENGINE MAINTENANCE
For basic engine maintenance, refer to the engine
maintenance section in this manual. For more detailed
engine maintenance, refer to the Honda Engine Owner's
manual furnished with the engine.
TOWING TIPS
CAUTION
DO NOT tow or lift the mixer unless the mixing drum
is completely empty.
CAUTION
Use a lifting device to lift tow bar onto vehicle coupler. If
lifting device is not available, have 2 persons of similar
height lift the tow bar. When lifting, do not attempt to lift
by bending forward. Bend hips and knees to squat down
to your load, keep it close to your body, and straighten
your legs to lift.
OPTIONAL TOW BARS
This mixer can be configured for use with various types of
tow bars (ball, loop and pin). Reference Figure 2.
Contact Discount-equipment for the desired tow bar.
HBC-1
Figure 2. Optional Tow Bars
HLC-1
HPC-1