MULTIQUIP Essick Series Operation And Parts Manual page 37

Lug Nut Torque Requirements
It is extremely important to apply and maintain proper
wheel mounting torque. Be sure to use only the fasteners
matched to the cone angle of the wheel. Proper procedure
for attachment of the wheels is as follows:
1. Start all wheel lug nuts by hand.
2. Torque all lug nuts in sequence. See Figure 43. DO NOT
torque the wheel lug nuts all the way down. Tighten
(torque) each lug nut in 3 separate passes as defined
by Table 11.
NOTICE
NEVER use an pneumatic air gun to tighten wheel
lug nuts.
3. After first road use, retorque all lug nuts in sequence.
Check all wheel lug nuts periodically.
1
4 3
2
4-LUG NUTS
1
6 3
4 5
2
6-LUG NUTS
LUG NUT
Figure 43. Wheel Lug Nuts Tightening Sequence
EM12M SERIES PLASTER/MORTAR MIXER • OPERATION AND PARTS MANUAL — REV. #2 (09/09/19) — PAGE 35
1
3
4
5
2
5-LUG NUTS
1
6 3
8 7
4 5
2
8-LUG NUTS
TORQUE
WRENCH
PNEUMATIC
AIRGUN
MAINTENANCE (MIXER)
Table 11. Tire Torque Requirements
First Pass
Wheel Size
FT-LBS
12" 20-25
13" 20-25
14" 20-25
15" 20-25
16" 20-25
MIXER STORAGE
For storage of the mixer for over 30 days, the following is
recommended:
„ Drain the fuel tank completely, or add STA-BIL to the fuel.
„ Run the engine until the gasoline in the carburetor is
completely consumed.
„ Completely drain the oil from the crankcase and refill
with fresh oil.
„ Remove the spark plug, pour 2 or 3 cc of SAE 30 oil into
the cylinder and crank slowly to distribute the oil.
„ Slowly rotate the engine a few times with the starter rope
and install a new plug.
„ Pull out the starter rope slowly and stop at the
compression point.
„ Clean the entire mixer and engine compartment.
„ Clean drum of all debris and foreign matter.
„ Clean all external parts of the mixer with a cloth.
„ Cover the mixer and place it a clean dry area, that is
protected from harsh elements.
Second Pass Third Pass
FT-LBS FT-LBS
35-40 50-65
35-40 50-65
50-60 90-120
50-60 90-120
50-60 90-120