Technical Data; Dimensions; Mattress Dimensions; Weights - Invacare Etude Plus HC User Manual

Invacare® Etude Plus® HC

9 Technical data

9.1 Dimensions

All measurements are stated in cm. All angles are stated in
degrees. All measurements and angles are stated without
tolerances.
Invacare®reserves the right to change the stated
measurements and angles.
Low
219
A
102
B
C 20–60
138–178
D
The angle between the lower leg section and horizontal is
adjustable from 0º to 15º.
Bed with tilt function

9.2 Mattress dimensions

Side rail: height
Verso HC
Min. density: 38kg/m 3

9.3 Weights

Max. patient weight
(provided that the weight of the
mattress and the accessories do not
exceed 35 kg)
Max. safe working load
(patient + accessories)
20
Etude Plus HC
High
219
102
27–67
145–185
Mattress measures (in cm):
Min. Max. Min.
height width
14 16 90
165 kg
200 kg
Etude Plus standard bed, complete, excluding
accessories
Etude Plus auto-regression, complete,
excluding accessories
Etude Plus bed end – 1 piece
Mattress support, standard head end
Mattress support with auto-regression, head
end
Mattress support with auto-regression, head
end, without actuator and control box
Mattress support, foot end
Verso HC side rail – 1 piece
Lifting pole
Mattress support extension (10 cm)
Mattress support extension (20 cm)
Support handle 40 x 30 cm
Support handle 40 x 40 cm
Swivel handle

9.4 Environmental conditions

Temperature
Relative humidity
Atmospheric
pressure
Be aware that when a bed has been stored under
low temperatures, it must be adjusted to operating
conditions before use.

9.5 Electrical system

Voltage supply: Uin = 120 Volt, AC, 50/60 Hz (AC =
Alternating current)
Maximum current input: Iin max. = 1.6 A
Intermittent (periodic motor operation): Int = max. 10%, 2
min ON / 18 min OFF
Degree of protection: IPx6* or IPx4** (depending on
configuration)
The control unit, external power supply and motors are
protected according to IPx6. When the bed is equipped
with a HL80 hand control, it is protected according to IPx4
Min.
Insulation class: Class II
length
190
Type BF Applied Part
Applied Part complying with the specified requirements for
protection against electrical shock according to IEC60601-1.
(An applied parts is a part of the medical equipment which
is designed to come into physical contact with the user
or parts that are likely to be brought into contact with
the user.)
Sound level: 45 – 50 dB (A)
77.3 kg
82.7 kg
17.9 kg
24.1 kg
27.9 kg
24.1 kg
17.4 kg
7.4 kg
4.2 kg
3.2 kg
5.5 kg
1,6 kg
2,0 kg
1,8 kg
Storage and
Operation
transportation
-10°C to +50°C +5°C to +40°C
20% to 75%
800 hPa to 1060 hPa
1579562-B