Installing The Rack Server; Accessing The Server In The Rack - HP ProLiant ML350 Generation 4p User Manual

76 HP ProLiant ML350 Generation 4p Server User Guide

Installing the Rack Server

To install the rack server:
1. Install the server into a rack ("Installing the Server into the Rack" on page
37).
2. Connect the power cord and peripheral devices. Refer to Rear Panel
Components (on page 12) for connector locations.
3. Power up the server ("Powering Up the Server" on page 25).
4. Install the operating system ("Installing the Operating System" on page 44).
5. Register the server. To register a server, refer to the registration card in the
HP ProLiant Essentials Foundation Pack or the HP Registration website
(http://register.hp.com).

Accessing the Server in the Rack

To perform some installation or maintenance procedures, the server must be
extended from the rack ("Extending the Server from the Rack" on page 26).
If the maintenance procedure requires accessing the server rear panel:
1. Unlock the cable management arm and swing the arm away from the server.