Wire The Receiver(S) - KVH Industries TracVision R5 Installation Manual

Wire the Receiver(s)

8
Do not use a screw-on, push-on, or
twist-on connector. Low quality
connectors will degrade system
performance and allow water/rain to
penetrate the cable.
10
If you cut the RF cable(s), be sure to use an Augat IT1000
crimp/strip tool (KVH Part # 19-0242) to attach an F-connector.
Augat IT1000 Crimp/Strip Tool and F-connector
1. Connect the RF1 cable to the receiver's "Satellite
In" connector.
SATELLITE IN
Receiver "Satellite In" Connector (Example)
2. Connect one end of the supplied ground wire to
any suitable screw on the receiver's rear panel
with a good contact with the receiver chassis.
Route the other end to the switchplate location.
3. If you need to connect a second receiver, connect
the RF2 cable and a second ground wire to the
second receiver. If you need to connect more than
two receivers, you will need to install an active
multiswitch; see Appendix B on page 22.
TV ANT/CABLE IN
(NOT SATELLITE)
DIGITAL
AUDIO OUT
R L
OUT TO TV
DATA PORT
AUDIO VIDEO S-VIDEO
SATELLITE IN
PHONE JACK
54-0359 Rev. A