Tools Required - Ioline FlexJet Series Upgrade Instructions

**Note: This procedure is only required if your firmware is older than version 264.0
Notices:
Attention!
included ground strap during all procedures. Keep plastic objects away from the keypad and logic board
assemblies.

Tools Required:

Scotch Tape
1
Service Station centering
1) Remove the right side cover of the machine.
3) Remove the carriage cover. (One screw on the right side,
un-clip the back right and left sides).
Screw
Procedure: Y fine adjustment for the Service Station.
The discharge of static electricity may damage the keypad and components. Use the
Pull out on the tabs
to remove the cover.
2) Remove the (four) Phillips screws that hold the keypad
on. Let the keypad hang. Make sure both ends are still
plugged in.
4) Make sure the ink cartridges are installed and power
the machine on.
Keypad