Ioline FlexJet Series Upgrade Instructions page 15

3
Final screw adjustment
1) If you are happy with the spacing between the carriage
and the service station turn the service station stop
screw on the side of the machine until it just touches
the service station.
3) Move the carriage catch bracket until it hits the
magnet. Tighten the nut to hold the stop bracket.
Note: It's best to use a nut driver that can reach
the nut while the carriage is in the service station.
Otherwise tighten the nut enough to hold the bracket
and move the carriage out of the service station to
Service station
"stop screw".
Nut
Magnet w/
rubber
bumpers
Carriage catch bracket
2) Back the screw off one half turn until you can see a
little bit of light between the screw and the service
station. Apply Lock-Tite or Super-Glue to the screw so
it won't back out while the machine is running.
4) If you are happy with all the adjustments, turn the
power off on the machine.
5) Let the FlexJet sit for 10 seconds, then turn the power
back on while holding the "Up" arrow on the keypad.
When the carriage starts to move let go of the button.
6) When the carriage initializes into the service station
check all the gaps and stop brackets to make sure the
adjustments are still right.
7) Re-install the keypad. Run a test plot to the machine
before putting the covers back on.
8) If problems arise contact Ioline Tech Support.
Very small gap