Table of Contents
Advertisement
6.4 PERFORMING PRESET OPERATIONS
JK-UC1/VLC485
Input the desired preset using the numeric keypad.
Press the PRESET button to perform the preset.
6.5 PAN/TILT FUNCTIONS
Manual PAN
Manual Pan is controlled from a keyboard and the speed ranges from 0.1 degrees/sec to 90
degrees/sec depending on the joystick position. In turbo mode the speed is 150 degree/sec. However,
this speed is limited when Proportional P/T is ON.
Manual TILT
Manual Tilt speed ranges from 0.1 degrees/sec to 45 degrees/sec. However, this speed changes
when Proportional P/T is ON.
Pan Range
Tilt Range
Manual Pan Speeds
Manual Pan Speeds (turbo)
Manual Tilt Speeds
Preset Speeds
6.6 SCAN FUNCTIONS
AUTO SCAN
The dome camera can perform an auto scan operation during power-up or by direct control from a
keyboard.
Scan limit stops ARE NOT set:
The dome camera will pan continuously until a manual pan, tilt, or zoom operation is performed
from the keyboard.
Scan limit stops ARE set:
The dome camera will pan continuously between scan limit stops until a manual pan, tilt, or zoom
operation is performed from the keyboard. To set scan limit stops refer to SCAN LIMIT STOPS
under PAN/TILT SETUP in the camera menu.
Zoom
At power-up, the zoom is fully zoomed out. When an auto scan is started directly from the keyboard,
the zoom will maintain the last magnification.
Tilt
At power-up, the tilt is set up by the menu. To set the tilt angle, refer to SCAN TILT ANGLE under
PAN/TILT SETUP. When an auto scan is started directly from the keyboard, the tilt will maintain the
last tilt angle.
360 degrees continuous
85 degrees (Indoor), 92 degrees (Outdoor)
0.1° – 90°/s
150°/s
0.1° – 45°/s
Pan: 400°/s max-set in menu
Tilt: 200°/s
- 9 -
Advertisement
Table of Contents
