Table of Contents
Advertisement
(IK-DP30A dome base install)
(11) Attach the video cable (included with the dome
accessories) to the video connector of a dome
base. [Note: Do not connect a thick coaxial cable
to a dome camera. There is a possibility of
damaging a connector. Be sure to use the cable
included in the dome accessories.]
(12) Communication cables are directly inserted in
the terminal of the dome base.
(13) Tighten the screw to secure the dome base to
the housing. Fig-5 qwe
(IK-DP30A dome drive install)
(14) After setting up DIP-SW in the top of the dome (See
8.Switch setting), connect the support wire to the hook of
the dome base. Fig-6 q
(15) To lock the dome drive to the dome base, line up the
notch with the label and turn to the right with both
hands. Fig-6 w
Ensure that the location of the notch (position of yellow paint) on the
dome base and the location of the installation label on the dome
drive are aligned.
(JK-H01A dome cover install)
(16) To lock the dome cover, insert the support wire and turn to the right with both hands.
Fig-7, Fig-8
(17) The installation is complete.
Fig-7
- 36 -
w
q
FIg-5
q
w
Fig-6
Fig-8
e
Advertisement
Table of Contents
