Table of Contents
Advertisement
9. Installation
JK-H01A is a housing for ceiling mount of the Toshiba dome camera.
1. IK-DP30A Installation procedure
(1) Carefully inspect to insure all parts
are present and remove all parts
from the box.
(2) A template is included for ease in
cutting the mounting hole. First,
locate a position in the ceiling for
a 9.020.08" (2292mm) hole to be
drilled. Trace around the template,
then cut a hole in the ceiling
following the trace lines. [Note: The
thickness of a ceiling to which this
housing can be attached is 0.08-
1.77" (2-45mm).]
(3) Remove the dome cover. To
separate the dome cover from the
housing, turn the cover to the left
with both hands. This dome cover
is connected to the top housing
with the wire. Fig-1
(4) Loosen the lock screw according
to ceiling board thickness for
attaching to the ceiling.
(5) Install the camera mounting
screws that came with the camera.
Do not fully tighten the screws.
Lock
screw
- 34 -
Fig-1
Lock
screw
Advertisement
Table of Contents
