Recording Your Greeting Message; Other Settings - Panasonic KX-TGH720E Operating Instructions Manual

3
Enter the current hour and minute.
Example: 9:30
09 30
R You can select 24-hour or 12-hour
clock format ("AM" or "PM") by
pressing *.
4
MOKN a M N
Recording your greeting
message
You can record your own greeting message
instead of using a pre-recorded greeting
message. See page 42 for details.
1
MMENUN (right soft key) #302
2
MbN: "Yes" a MOKN
3
Record a greeting message. a MSTOPN
a M N

Other settings

Screen saver mode
The backlight dims when on a call or turns
off completely after 1 minute of inactivity if
the handset is not on the base unit or charger.
Activate the handset display again by:
– pressing MCN when on a call.
– pressing any dial key at all other times.
Eco mode
The following settings are available for eco
mode.
– "Eco": Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
displayed on the handset display instead of
.
– "Eco Plus": Reduces the base unit
transmission power completely in standby
mode.
When this setting is selected,
displayed on the handset display instead of
.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
– "Off" (default setting): Turns off eco mode.
When this setting is selected,
are not displayed in the handset display.
Setting the eco mode
1
MMENUN (right soft key) #725
2
MbN: Select the desired setting. a MOKN
a M
Note:
R If there is a handset that is not compatible
with Eco Plus registered to the base unit,
"Eco Plus" is not available. If that
handset is registered while "Eco Plus"
was already selected, the setting changes
to "Off".
R When there is another cordless phone in
use nearby, the base unit transmission
power may not be reduced. (KX-TGH722/
KX-TGH723)
R When eco mode is set to "Eco Plus",
there is a delay between when calls are
received and when the handset starts
ringing.
R If the handset is registered to multiple base
units, the handset may not be able to make
or receive calls or communicate with the
base unit when the following conditions are
met.
– Eco mode is set to "Eco Plus"
(page 15).
– Base unit selection is set to "Auto"
(page 32).
In this case, place the handset near the
base unit, and change the setting to "Eco"
or "Off". Repeat for each base unit.
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to "On"
(page 38):
– Eco mode is disabled.
is
– "Eco Mode" is not displayed in the
display menu (page 31).
R When eco mode is set to "Eco Plus",
battery usage time is shortened (page 12).
is
Getting Started
N
/
15