Newco FKP-4T Manual page 8

Turn the power switch to the "OFF" position and plug the machine into a
properly installed and grounded electrical circuit. Turn on power switch to
start the initial WATER FILL CYCLE.
1. PLACE CUP UNDER BREW NOZZLE ON DRIP TRAY
2. SELECT COFFE, TEA, OR ESPRESSO
3. UNWRAP THE POD & PLACE IN CENTER OF BREW CHAMBER
4. M A K E S E L E C T I O N S A N D PRESS THE BREW BUTTON-
DRAWER WILL CLOSE & BREW CYCLE WILL START
5. ONCE THE POD DRYING CYCLE IS COMPLETE, THE POD WILL
EJECT & THE CUP CAN BE REMOVED
This screen will display momentarily with
hardware and software revision levels.
This will be displayed until water level reaches
the liquid level probe.
When tank is filled, the heater circuit will turn
on - allow up to 20 min for the tank to reach
brewing temperature.
This will be displayed while tank is heating.
When the tank temperature reaches its set
point, the selection screen will be displayed.
Machine is now ready for programming or
operation.
BREW OPERATION
8