Table of Contents
Advertisement
The FM Standards are available from:
1151 Boston-Providence Turnpike
PO Box 9102
Norwood, MA 02062
www.fmglobal.com/approvals
Information on the EN standards and where to get
them is available from:
Comité Européen de Normalisation
Stassartstraat 36
B-1050 Brussels
Phone: +32-25196811
Fax: +32-25196819
www.cen.eu
Comité Européen de Normalisation Electronique
Stassartstraat 36
B-1050 Brussels
Phone: +32-25196871
Fax: +32-25196919
www.cenelec.org
Checklist Before Installation
Air Supply
To admit fresh combustion air from outdoors, provide
sufficient opening in the room to allow fresh air to enter
according to local regulations.
If there are corrosive fumes or materials in the air, then
supply the burner with clean air from an uncontaminated
area.
Exhaust
Do not allow exhaust fumes to accumulate in the work
area. Provide some positive means for exhausting from
the furnace and the building.
Access
Make sure that you install the burner in such a way that
you
can
gain
easy
maintenance.
Environment
Make sure the local environment matches the original
operating specifications. Check the following items:
• Voltage, frequency and stability of the electrical
power
• Fuel type and supply pressure of the fuel
• Availability of enough fresh, clean combustion air
• Humidity, altitude and temperature of air
• Presence of damaging corrosive gases in the air
• Prevent direct exposure to water
Eclipse Furnnox Burner, V1, Installation Guide 210, 2/14/2011
access
for
inspection
Electrical Supply
The burner should be controlled via a sequence
programmer, approved according to the local standards.
For connections, please refer to the related wiring
diagrams.
■ Wiring to the burner must be in accordance with
current wiring standards. It is vital that the live and
neutral wires are connected correctly as reversal
could present a hazard. Also the grounding must
be checked to ensure a good connection.
■ Gas pipe work must NOT be used for grounding
purposes.
■ If burner control signals are supplied via a flame
safeguard control panel provided by others,
Eclipse can not accept any responsibility for
incorrect interfacing.
Prepare the Burner
Several components must be installed on a burner before
it can operate. Installation instructions follow.
It is possible to change the relative position of the gas inlet
with respect to the air inlet. This can be convenient for the
routing of the piping.
Rotate the Rear Cover
(On Standard Body Only, Optional)
To rotate the rear cover, do the following (see Figure 3.1):
1. Disconnect the piping at a union in the piping or the
inlet flanges
NOTE: Be careful not to lose or damage the orifice
plate or the o-rings.
and
2. Remove the four bolts
3. Remove the rear cover
4. Rotate the rear cover
5. Put the rear cover
housing
.
6. Install the four bolts
7. Reconnect the piping. Make sure that the o-rings
show no signs of damage.
WARNING
provided on the burner.
.
from the burner housing
to the position that you want.
in position against the burner
.
.
7
Advertisement
Table of Contents
Troubleshooting
