Outline Of Preparation Procedure Before Operating The Ecr - TEC MA-156-1 SERIES Owner's Manual

3. Outline of Preparation Procedure Before Operating
the ECR
This chapter shows the outline of set-up procedure of the ECR before actually starting
the ECR operation.
1
Remove the cash register from the carton, referring to
Chapter "2. Unpacking" on page 2. And take out all
the parts and accessories.
2
Remove the tapes and seals that are holding parts or
protecting the register surfaces.
3
Plug the power cord of the register into a wall outlet.
Make sure that the outlet voltage matches that of the
power required for the register.
WARNING: Be sure to plug in the power cord first, then insert the
batteries.
4
Detach the Printer Cover and the Battery Cover, then
insert the batteries (3 pieces). After inserting the
batteries, attach the Battery Cover.
WARNING: Be certain to insert the batteries enclosed in the
5
Set the Mode Select Switch to the REG position.
package. If they are not insert and the power is
turned OFF (including a power failure occurrence),
the sales data and the programmed data will be
cleared.
- 3 -
EO1-11099
SET
OFF
REG
X
Z