Toshiba RAS-10GAVP-E Service Manual page 96

No. Part name
‡
Compressor 1) Perform work of item 1 of
2) Extract refrigerant gas.
3) Remove the partition board.
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor,
6) Remove pipe connected to the compressor
7) Remove the fixing screw of the bottom plate
8) Remove the fixing screw of the bottom plate
9) Pull upward the refrigeration cycle.
10) Remove BOLT (3 pcs.) fixing the compres-
ˆ
Reactor 1) Perform work of item 1 of
2) Remove screws fixing the reactor.
Procedure
…
.
(ST1TØ4 × 8L 3 pcs.)
and disconnect lead wire of the compressor
from the terminal.
with a burner.
• Take care to keep the 4-way valve away
from naked flames. (Otherwise, it may
malfunction.)
and heat exchanger. (ST1TØ4 × 8L 1 pc.)
and valve fixing plate.
(ST1TØ4 × 8L 1 pc.)
sor to the bottom plate.
* Precautions when assembling the com-
pressor.
Tighten the compressor bolts using a
tightening torque of 4.9 N•m.
(ST1TØ4 × 8L 4 pcs.)
 ‚ ƒ „
and , , ,
Partition
board
‚ ƒ
, and .
– 96 –
Remarks
Valve
fixing
Compressor
plate
Reactor