Toshiba RAS-10GAVP-E Service Manual page 87

No. Part name
†
Bearing 1) Follow to the procedure in the items
2) Remove the two fixing screws used to secure
3) Raise the left side of the heat exchanger
<Caution at assembling>
• If the bearing is out from the housing, push it
• After assembling the bearing base, check that it
Procedures
the left edge panel of the heat exchanger, and
remove the two screws used to secure the
bearing base.
slightly, and remove the bearing base.
into the specified position and then incorporate
it in the main body.
is fitted into the stepped part of the drain pipe.
Bearing base

.
Drain pipe
– 87 –
Remarks
Screw
Bearing
base
Screw
Raise the left side
Remove in this direction
Bearing base
Bearing
Drain pipe