Operating Procedure - Stanley Avdel ProSert XTN20 Instructions Manual

E N G L I S H
4.3.1. Stroke Adjustment (see Fig. 1A & 3).
To use this tool in stroke set operation, screw the Pressure Regulator 19 fully in to achieve full pressure then
adjust Stroke Setter to the desired stroke length:
• Open
End Cap Assembly
• The Stroke Locking Pin 13 will be released.
• Directional arrows indicate stoke direction.
• Increase the stroke from the minimum until optimum deformation is obtained.
• The scale gives an indication of the current stroke length.
• Stroke indication markings 12 are shown on the End Cap fi g. 1A
• Line the rear of the Stroke Setter 14 up with these marks to achieve desired stroke length.
• Each Recess 15 on the Stroke Setter 14 is equal to +- 0.1mm of stroke.
• Close the
End Cap Assembly
• The Stroke Lock will activate when the
position
• The tool is now ready to operate.
4.3.2. Pressure Adjustment (see Fig. 1B & 3).
To use this tool in pressure set operation, wind the Stroke Setter 14 to 7mm, then screw the Pressure
Regulator 19 fully out to achieve minimum pressure then adjust to the desired pressure:
• Initially the Blind Rivet Nut will not deform and the tool will spin off .
• Screw in the Pressure Regulator 19 by 1 groove on the regulator body and test.
• Repeat the operation with the Pressure Regulator 19 until optimum deformation is obtained.
• 1 notch on the Pressure Regulator 19 is equivalent to approximately 20N of pulling force.
• After a successful Blind Rivet Nut deformation, check the Blind Rivet Nut and increase the force if
necessary.
• Increase by 1-2 notches extra to allow for variation in the Blind Rivet Nuts.
• The tool is now ready to operate.

5. Operating Procedure

Installing a Blind Rivet Nut (see Fig. 3).
To install a Blind Rivet Nut.
• Check that the correct Blind Rivet Nut has been selected.
• Push Blind Rivet Nut into the application.
• Check Nose Assembly is at right angle (90°) to the work.
• Push onto the Blind Rivet Nut with the tool to spin on.
• Once fully and correctly inserted, depress tool Trigger 20 switch to start installation cycle.
• Hold the Trigger 20 until the Blind Rivet Nut is completely set and the tool has disengaged completely.
In the event a Blind Rivet Nut becomes jammed in an application press the Manual Reverse Trigger 17 to
reverse the Mandrel 1 and spin off the Blind Rivet Nut. Alternately disconnect from the air supply and use the
4mm Pin Punch 21 supplied in the Maintenance Kit to wind off the Mandrel through the Nose Casing 4 shown
in the fi gure 1.
CAUTION - do not attempt to force the installation of an insert as this will cause damage to the tool and/or
application.
12
11.
11 before using in the application environment.
End Cap Assembly
11 is closed when the tool is in the upright