Weslo Momentum CT 5.8 User Manual page 10

10. Identify the Left Pulse Bar (90), which is marked
with a "Left" sticker. Orient the Left Pulse Bar so
that the hexagonal holes are in the indicated
location.
Have another person hold the Left Pulse Bar (90)
near the Upright (2).
See the inset drawing. Locate the wire tie in the
Upright (2). Tie the lower end of the wire tie to the
left Pulse Wire (96). Next, pull the upper end of the
wire tie upward out of the top of the Upright. Then,
untie and discard the wire tie.
Tip: Avoid pinching the wires. Slide the Left
Pulse Bar (90) onto the left side of the Upright (2).
Attach the Left Pulse Bar with two M8 x 38mm
Button Bolts (94) and two M8 Locknuts (59). Make
sure that the Locknuts are in the hexagonal
holes.
Repeat this step for the Right Pulse Bar (91).
11. The Console (10) can use four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been exposed
to cold temperatures, allow it to warm to room
temperature before inserting batteries.
Otherwise, you may damage the console dis-
plays or other electronic components. Remove
the battery cover, insert the batteries into the battery
compartment, and reattach the battery cover. Make
sure to orient the batteries as shown by the dia-
gram inside the battery compartment. Do not
combine old and new batteries or alkaline and
rechargeable batteries.
All manuals and user guides at all-guides.com
10
10
Wire Ties
94
2
96
90
59
Avoid pinching
the wires
Wire Tie
96
11
Screw
Battery
Cover
10
96
91
Hexagonal
Holes
Batteries