Mounting A Button Cap - Bosch PRAESENSA Installation Manual

PRAESENSA
13.5.4

Mounting a button cap

The call station extension has provisions to add a cap over one or more buttons, as a
safeguard against accidental activation. Each PRA-CSE is delivered with a set of three caps,
each consisting of a white light ring with pivot pins and a red cap with a hinge.
To mount a button cap, follow the procedure below:
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems B.V.
The extension top cover is fixed in place with magnets. Use a screwdriver or tweezers in
the slot of the extension cover plate to lift up the top cover.
Slide the cover upwards to remove it and get access to the buttons.
Translucent light rings are placed in rows of three around the buttons. Use tweezers to
lift and remove the row for the button that should get a cap.
Remove the original light ring by cutting the plastic bridges to the adjacent light rings.
Leave part of the plastic bridges in place around each light ring for better orientation
when it is put back in place.
Insert one of the new light rings with pivot pins in the slot around the button that should
get a cap. The pivot pins must be on top.
Then place the original light rings back around the remaining buttons.
Mount the cover back on the extension body by first sliding the bottom side into the
body, then tilt down until it snaps into place.
Installation manual
Call station extension | PRA-CSE | en 149
2019.11 | V1.00 |