Surround Sound - Mercedes-Benz Audio 20 Operating Instructions Manual

Harman/kardon
94
Adjusting the balance/fader
Balance adjusts the volume left and right. Fader
adjusts the volume in front and rear.
For the best sound, setting 0 is recommended.
Call up the sound menu (
X
Turn the controller until
X
the center.
Slide 6 the controller.
X
To activate the menu for balance and fader:
X
press the controller.
To adjust the balance: slide 8 or 9 the
X
controller.
To adjust the fader: slide 6 or 5 the con-
X
troller.
An image shows the sound focus set.
To return to the basic menu: press the %
X
button briefly.
Setting surround sound
The Logic7 setting optimizes the sound play-
back.
Call up the sound menu (
X
Turn the controller until
X
ter.
® ®
Logic 7 surround sound system
page 93).
Y
Balance/Fader is in
page 93).
Y
Logic7 is in the cen-
Slide 6 the controller.
X
The left-hand rotary menu to switch surround
sound on and off is activated.
To switch Logic7 on or off: turn the control-
X
ler.
To return to the menu: slide 5 the control-
X
ler.
To return to the basic menu: press the %
X
button briefly.
For the optimum audio experience for all pas-
®
sengers when Logic7
ance settings should be set to the center of the
vehicle interior.
MP3 tracks should have a bit rate of at least
128 kbit/s.
Surround sound playback does not function for
mono signal sources, such as for AM radio
mode.
If radio reception is poor, e.g. in a tunnel, you
should switch off Logic7
wise switch dynamically between stereo and
mono and cause temporary sound distortions.
is switched on, the bal-
®
, since it may other-