Relay Test; Sensor Test; Language Selection - KAEL Muhendislik Elektronik TC - PT100 Manual

MENU
the operating states of the sensors and general settings where the
settings are made. The parameters in the menu can be accessed with
the arrow keys and enter into the setting or test section with the
Select button and exit with the exit or cancel button
NOTE-1: If the password is activated,then settings section is
NOTE-2: When entered in the Menu or Report section of the

1. RELAY TEST

is pressed, the RELAY TEST section is entered. In this case, the operation of the device is stopped.
ALARM, TRIP, FAULT, FAN relays go to OFF position. The up and down arrow keys are used to
switch between relays and the relay position changes each time the SET key is pressed. Exit button
will exit this page and return to Menu page.
Never enter the Relay Test Area while the device is connected to the system. System and device
may be damaged.
11/10/2016 14:25
Next

2. SENSOR TEST

states of the sensors and if an error exists
it displays the error.
The result of the test is an open circuit.
A closed circuit, an OK signal which means
that is not plugged in and that there is no
fault.Test start with Start button and it is
completed between 20-30 seconds.
Operational statuses are shown next to
the channel numbers. Exit button will exit
this page and return to Menu page.
3. SETTINGS
related to the device are made. It is
entered with password. Language,
Temperature Unit, Channel 4, Alarm,
Trip, Fan, Fault, Password and Date-
Time can be set respectively.

3.1 LANGUAGE SELECTION

This can be selected when the unit is first powered on, or it can be
entered and changed later.
Control of the contacts of the output relays, detailed testing of
entered by the password.
homepage, it will automatically return to the
Homepage screen if it any button was not clicked
for 2 minutes.
It gives the warning message on the side before entering this section. If the Continue button
ATTENTION!
The relays switch OFF if
you proceed. Ensure that
the system would not be
damaged
Cancel
The sensor test tests the operating
This is where the settings
Available in Turkish, English, Russian languages.
11/10/2016 14:25
RELAY TEST
Control the
ALARM
contactors of
the relay with
TRIP
multimeter
during the test
FAULT
opeation
FAN
Set Exit
11/10/2016 14:25
SENSOR TEST
ch1
ch2
ch3
ch4
Start
11/10/2016 14:25
SETTINGS
English-Pyccкйй-Türkçe
►
Temprature Unit Settings
Channel 4 Settings
Alarm Settings
Trip Settings
Fan Settings
Select
11/10/2016 14:25
MENU
Relay Test
►
Sensor Test
Settings
Reset to Factory Settings
Select
11/10/2016 14:25
RELAY TEST
Control the
ALARM
contactors of
the relay with
TRIP
multimeter
during the test
FAULT
opeation
FAN
Set
11/10/2016 14:25
SENSOR TEST
ch1
Unplagged Sensor
ch2
ch3 Open Circuit
ch4
Exit Start
11/10/2016 14:25
SETTINGS
Fan Settings
Fault Settings
Password Settings
Date Time Settings
Exit Select
11/10/2016 14:25
LANGUAGE SET.
English – Pyccкйй – Türkçe
English
Exit
Exit
Exit
Exit
Set